A Penis Enlargement Guide Using A Penis Pump

In recent years, penis pumps have become increasingly popular as far as penis enlargement is concerned. It looks like the doubts that men have since had pertaining to the effectiveness of the device are slowly being cleared. One of the reasons why penis pumps are gaining popularity might have to do with the fact that it is non-invasive and doesn’t entail consumption of chemicals. They feel it is a lot safer compared to other methods of penis enlargement.

Further, the operations of the device are not complicated at all- it’s really simple. Rather than use your hands to manually conduct penis exercise for enlargement, the device utilises pumping on your behalf. Your only responsibility is to make sure that the gadget is well fixed on your penis as instructed. Before you rush and purchase a penis pump in order to enjoy its incredible benefits, it is important for you to understand a few basics.

Steps to using a penis enlargement pump

  • For starters, you must understand that different penis pumps have varying cylinder sizes. You are supposed to insert your penis into the cylinder. You are advised to avoid selecting a cylinder that is bigger than your organ. This is very risky as your scrotum could be pulled into the cylinder- you really don’t want this to happen. On the other hand, a small cylinder will be incapable of providing your cock with sufficient space for it to expand. For this reason, it is highly recommended that you opt for a cylinder where your penis fits well.

  • A good penis pump must have a pressure gauge as well as a release gauge. This will give you improved control of the amount of pressure you subject to your manhood. Note that all penis pumps aren’t designed the same. Of utmost importance is to ensure that you are able to control the pressure exerted. This is critical to eliminating, or at the very least, minimising potential risks associated with the use of penis pumps. It is better to be safe than sorry.

  • When your penis pump has been delivered, you don’t use it straight away. Instead, you are supposed to wash it using hot water. Dish washing or liquid hand washing soap should be used to get rid of any harmful bacteria on your new device.

  • Prior to using the penis pump, ensure the penis area is shaven. This is done to facilitate a good seal on the device. Besides, you don’t want to experience pain as the penis hair locks into the cylinder- it is not a good experience.

  • Just like when using other devices of penis enlargement, penis exercises or rather warm ups are highly advised. The objective is to stimulate circulation of blood and reduce chances of penis trauma. Alternatively, you may wrap a towel soaked in hot water around your penis for around two minutes. This should be repeated thrice while ensuring to rinse the cylinder of the device using hot water as well.

  • The next step entails application of Vaseline of the penis area that comes into contact with the cylinder. This should be done when the penis is semi-erect. It promotes better anchorage. The cylinder should then be placed on top of the penis, pressurise slowly until some discomfort is felt- but not pain. The pressure should be held for ten minutes before letting go. Between the ten minutes sessions, spend 3 minutes massaging the penis. The ten minutes sessions should be repeated until the penis returns to its flaccid state.

  • Finish with warm up exercises and then rinse the cylinder using hot water and a detergent.

Check Out Our Independent Review On
The Top 5 Penis Enhancement Pills (Comparison Table)